These are USED Holding Valves. This listting is for "SHORT" Frame models often called L7/M7 valves and others. Used on Small wheel 220,222,224,226 and "Short" Frame pre 1980 444, 446, 448. Includes one USED valve, hard lines and fittings for valve being shipped. You may or may not need the fittings included depending on your tractor. Your lines you get with valve may very. But they will be set up for your "short" frame tractor. Different years had different fittings used on rear and travel valve so you may need to swap the fittings included or it may go on as is. Fittings are either straight Fittings or 90 degree fittings. YOU WILL BE SHIPPED A SHORT FRAME VALVE SET UP WITH TUBES AND FITTINGS. WE HAVE MANY AND THE PHOTO MAY NOT BE THE EXACT ONE YOU GET.
Wont fit loaders or "LONG"Frame 400 series. We have listings for Long Frame and Loader holding valves seperate on this site.
HOLDING VALVES ARE A MUST AND NEEDED FOR SAFTEY. Esspecially if you have any hills or inclines. They prevent "freewheeling" down hill. So within reason what ever speed you start going down a hill at you will go don the hill the same speed top to bottom, forward or reverese. Valve hooks between Travel Control Valve And Rear End in Place of the 2 large tubes you have.
After the mid 1980's all Case Ingersoll models had built in holding valves.
Fully Insured Shipping
READ- USED PARTS HAVE NO WARRANTY. THEY ARE SOLD AS IS AND UNTESTED UNLESS NOTED OTHERWISE. THE ITEM IN THE PHOTOS IS A REPERSENTATION OF THIS USED PART NUMBER, NOT NECESSARILY THE ONE YOU ARE GOING TO RECEIVE. COLOR, FINISH, CONDITION MAY VERY. WE HAVE MANY, MANY USED PARTS AND MANY OF THE SAME PART NUMBER. YOU WILL RECEIVE THE BEST CONDTION ONE WE HAVE IN STOCK. ALL THAT SAID WE TAKE PRIDE IN EVERYTHING WE SELL NEW AND USED, WE TRY TO STEAM CLEAN AND DEGREASE ALL PARTS BEFORE SHIPMENT AND OFTEN QUCIK PAINT TOO. IF TIME PERMITS. THIS IS NOT GUARANTEED BUT WE TRY! ANY QUESTIONS OR CONCERNS PLEASE REACH OUT TO US.
SHOP TIP- If you have to change the 90 degree fitting on TOP port of drive motor and do not want to lower the rear you can saw the right angle part of the 90 fitting so you can then clear frame and unthread. We recommend downloading a holding valve Operators Manual.
